Digital Monitoring Products XR2500F Guia do Utilizador Página 12
- Página / 36
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
6 XR2500F User’s Guide Introduction
FAILED TO EXIT (ANTI-PASS BACK) (Burglary Keypad)
Anti-passback requires users to properly exit (egress) an area they
have previously accessed. If they fail to exit through the proper
card reader location they are not granted access on their next
attempt. A Failed to Exit message appears when a user assigned
the anti-passback option attempts to re-enter an area which they
did not exit properly. The user must exit the area through the
proper door. If not possible, your system administrator should
select the Forgive option in the User Codes menu option.
SYSTEM TROUBLE or SERVICE REQUIRED
There is a problem with one or more of the components in your
system. Contact our service department as soon as possible.
SYSTEM BUSY
The Security Command system is performing another task of a
higher priority. This usually only takes a few moments.
Special Fire Command Center Tones
Your keypad also contains a small speaker that alerts you about
events as they occur on your system. For an alarm, as soon as
the rst digit key is pressed to enter a user code, the tone stops.
If no other keys are pressed for ve seconds or an invalid code is
entered, the tone turns on again.
Fire Alarm tone: An intermittent sweeping siren that sounds until
the re alarm is silenced.
Key press tone: A short beep each time you press a key on the
keypad and it is acknowledged by the system.
Prewarn tone: A continuous pulsed tone that sounds when you
open an entry delay door on a system that is armed (turned on)
reminding you to disarm the protection. The tone silences as soon
as the rst user code digit key is pressed.
Exit tone: A continuous pulsing tone that sounds during the exit
countdown just after arming to remind you to exit the premise. At
ten seconds prior to the end of the countdown, the rate of pulsing
increases.
Trouble tone: A steady tone indicating a trouble condition on your
system. Press a Select key to silence.
What to do when the trouble tone sounds
You can silence the trouble tone by pressing any key.
This only silences the keypad and does not correct the
condition that originally caused the trouble.
- Fire Command Center 1
- Silencing an Alarm 2
- Security Command User’s Guide 3
- Emergency Evacuation Plans 5
- Introduction 7
- The Fire Command Center 8
- Using the Keypad 9
- User Options 10
- Four Function Keys 10
- User Menu 13
- Sensor Reset 14
- Alarm Silence 14
- Outputs On Off 15
- Zone Status 16
- System Test 17
- System Status 17
- User Proles 18
- User Proles Reference 19
- User Codes 20
- Setting the Date and Time 22
- Ambush Codes 23
- Display Events 23
- Service Request 23
- Fire Drill 23
- Appendix A 24
- Zone Event Displays 25
- Supervisory Event Displays 26
- System Monitor Event Displays 26
- Appendix B 27
- Output Groups Browser 28
- Outputs On/Off Browser 28
- Change User Proles Browser 29
- Add User Codes Browser 29
- Delete User Codes Browser 30
- Change User Codes Browser 30
- Appendix C 32
Manuais e produtos relacionados com Detetores de fumo Digital Monitoring Products XR2500F
(12 páginas)Sony VPL-HS1 Handbücher
Bedienungsanleitungen und Benutzerhandbücher für Heimkinosysteme Sony VPL-HS1.
Wir stellen 1 PDF-Handbücher Sony VPL-HS1 zum kostenlosen herunterladen nach Dokumenttypen zur Verfügung Bedienungsanleitung
Comentários a estes Manuais