Digital Monitoring Products Canadian XR100 Manual do Utilizador descarregar pdf (Página 14)

Establish Direct Connection

To directly connect your alarm panel to the Advanced Reporting Module, connect the

network cable from the panel’s 462N Network Interface Card or to the J21 Serial Connector

on an XR500 Series or XR2500F panel to a COM port on the computer running the Advanced

Reporting Module.

Enter all of the necessary information in the Connection Information section of the

Panel Information window. For more information see your System Link User’s Guide

(LT-0570) or Help File, or your Remote Link User’s

Guide (LT-0565) or Help File.

Also enter the proper information in the Modules

Tab. See the Direct Monitoring section on page

of this User’s Guide for more information.

If you wish to assign a special identification number

for events received over the direct connection, enter

a default receiver number that represents the events

received over the direct connection. See the

Default

Receiver section on page

13 of this User’s Guide for

more information.

Enable Host Monitoring

To connect to a network to monitor for reports, connect a network cable from the network

to the computer running the Advanced Reporting Module.

To monitor the network for panel events, enable Host Monitoring in the Modules Tab.

Select System > Configure > Remote Link > Modules Tab and place a check in the

Host Monitoring checkbox. See the

Host Monitoring section on page 14 of this guide.

If you wish to assign a special receiver number for events received over the network, enter

a default receiver number that represents the events received over the Host. See the

Default Receiver section on page 13 of this User’s Guide for more information.

1 2 ... 9 10 11 12 13 14 15 16 17 18 19 ... 23 24

Sem comentários

Digital Monitoring Products Canadian XR100 Manual do Utilizador Página 14