Digital Monitoring Products XR20 Guia de Instalação descarregar pdf (Página 17)

Installation

XRSuper6/XR20/XR40 Installation Guide

2500 N. Partnership Boulevard Springfield, MO 65803 www.dmpnet.com Digital Monitoring Products

13.4 Ground start

To configure the panel for ground start operation, you must install the appropriate ground start module and

program one of the panel's available annunciator outputs for Ground Start operation. Refer to the panel

Programming Guide for complete programming information. This option must not be selected on a UL listed

system.

Reset Jumpers J16

14.1 Description

There are two reset jumpers located at the top right of the panel's circuit board labeled RESET. Momentarily

shorting these jumpers allows you to reset the microprocessor. Resetting the panel allows you to enter the

panel's internal programmer.

To reset the panel when first installing the system, place the blade of a slotted screwdriver across the two reset

jumpers after applying power to the panel.

To reset the panel while the system is operational (for example, prior to reprogramming), you can short the

jumpers without powering down the system.

After resetting the panel for programming, you must begin within 30 minutes. If you wait longer than 30

minutes, you will have to reset the panel again.

UNIVERSAL UL BURGLARY SPECIFICATIONS

15.1 Introduction

The programming and installation specifications contained in this section must be completed when installing the

XRSuper6/XR20/XR40 in accordance with any of the UL burglary standards. Additional specifications may be

required by a particular standard.

15.2 Wiring

All wiring must be in accordance with NEC, ANSI/NFPA 70, UL 681, and UL 611 for all burglary installations.

15.3 Police station phone numbers

The digital dialer telephone number programmed for communication must not be a police station phone number,

unless that phone number is specifically provided for that purpose.

15.4 Bypass reports

The bypass reports option must be programmed as YES for all UL burglary applications. See the XRSuper6/XR20/

XR40 Programming Guide (LT-0305).

15.5 System maintenance

Proper installation and regular maintenance by the installing alarm company and frequent testing by the end user

is essential to ensure continuous satisfactory operation of any alarm system. Offering a maintenance program

and acquainting the user with the correct procedure for use and testing of the system is also the responsibility

of the installing alarm company.

15.6 Cross zoning

Zones used for cross zoning must be installed to allow detection of the same event. Cross zoning shall not

conflict with UL 681 or 1641.

15.7 Ground Start

Ground Start phone lines must not be used for UL listed systems.

15.8 UL Listed Receivers

UL has verified operation with the DMP SCS-1 Security Receiver, Sur-Gard SG-HLR2-DG, FBII CP220PB, Osborne-

Hoffman Quick-Alert and Radionics D6500 receivers.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 23 24

Comentários a estes Manuais

Sem comentários

Digital Monitoring Products XR20 Guia de Instalação Página 17

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Digital Monitoring Products XR20