Digital Monitoring Products Graphic Touchscreen Guia do Utilizador descarregar pdf (Página 37)

30 XR150/XR350/XR550 User’s Guide User Menu

System Test

System Test is used to test the battery, alarm bell or siren, and

communi cation to a central station. The System Test function

begins automatically as soon as you select it.

Note: If an area is in an armed state, the system test will not

operate.

Using the System Test Function

1. Access the User Menu.

2. PressCOMMANDuntilSYSTEMTEST?displays.

3. The keypad displays SYSTEM PANICS. Select SYSTEM.

3. The System Test begins automatically and the keypad

displays the following messages in this order:

1) BELL SOUNDING during a two second bell test

2) KEYPAD SOUNDING all keypads assigned to the same

areasoundtheirburglaryalarmtonefortwo(2)seconds

during the keypad sounder test

3) BATTERY - OKAY or BATTERY - TRBL to indicate the

battery condition

4)* TRANSMIT TEST NO: 1 during the transmit test

5) TRANSMIT OKAY or TRANSMIT FAILED to show the

results of the transmit test

6) TEST END to indicate the System Test is complete.

7) You canpresstheBackArrowkey to endthetransmit

test.

 *Thetransmittestdoesnotoccuronlocalsystems.

Using the Panic Zone Test (XR550N/E Only)

1. Access the User Menu.

2. PressCOMMANDuntilSYSTEMTEST?displays.

3. Press any Select key. The keypad displays SYSTEM PANICS.

4. Select PANICS.

5. The Panic Zone Test begins automatically and the keypad

displays TRIPS: END.

 DuringthePanicZoneTest,tripeachpaniczone(orbutton)

by pressing and holding the panic for 1 to 2 seconds.

Note:

YoudoNOThavetoholdthepanicfor2secondsinnormal

mode. The Panic Zone Test takes additional time to display when

the system is in test mode.

 Each time you trip a panic zone, the display number

incrementsandthekeypadbuzzersoundsfortwoseconds.

 Thenumberofpaniczonestrippedconstantlydisplaysuntil

thetestendsornopaniczoneactivityhasoccurredfor20

minutes.

6. SelectENDtostopthePanicZoneTest.

7. PANIC TEST OKAY displays when the Panic Zone Test is

completedandallzonestestedOK.

8. Whenthe Panic Zone Test endsand a zone failed(did not

trip) during the test, the keypad displays the zone name

andnumberandthebuzzersoundsforonesecond.Pressthe

COMMANDkeytodisplaythenextfailedzone.

Note: If testing a key fob, a message will not display if it fails, only

thevericationmessageisdisplayed.

Note:DuringthePanicZoneTest,anyzonesthatfailarenotsent

to the receiver unless pre-programmed at installation to be sent.

Note: Your system may be programmed to limit the Panic Zone Test

to only be performed during the Area 32 schedule.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 83 84

Comentários a estes Manuais

Sem comentários

Digital Monitoring Products Graphic Touchscreen Guia do Utilizador Página 37

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Digital Monitoring Products Graphic Touchscreen