Digital Monitoring Products XTL Series Guia de Instalação descarregar pdf (Página 7)

XTL/XTLC Installation Guide Digital Monitoring Products

system components

Installation

4.1 Mounting Location Information

A location should be selected that is centrally located between the 1100 Series transmitters used in the

installation.InstalltheXTL/XTLCawayfrommetalobjects.Mountingthepanelonornearmetalsurfaces

impairsperformance.Whenselectingthepropermountinglocationofatransmitter,refertotheLEDSurvey

Operationsectionofthespecicinstallationguideforthetransmitterbeinginstalled.

4.2 Mounting the Enclosure

TheenclosurefortheXTL/XTLCpanelmustbemountedusingtheprovided#6screwsinthefourmounting

holesshowninFigure1.Mounttheenclosureinasecure,dryplaceawayfrommetalobjectstoprotect

thepanelfromdamageduetotamperingortheelements.Mountthepanelaminimumof4feetfromany

wireless transmitters or repeaters. It is not necessary to remove the PCB when installing the enclosure.

Mounting Hole Locations

RESET

LOAD

BAT

PROG

RED

PWR

MODEL XTL

TX RF RX

Figure 1: Mounting Hole Locations

Primary Power Supply

5.1 DC Input

MounttheXTL/XTLCpanelnearawalloutletfortheModel372-500plug-inDCpowersupply.Inaddition

topoweringthepanel,theDCplug-inpowersupplyalsochargestheback-upbattery.The372-500mustbe

locatedwithin100feetofthepanelusing22AWGwire.Usethefollowingstepstoconnecttheplug-inpower

supply:

OBSERVE POLARITY

1. Using22AWGwire,connectthepanelPWR(J2)rstterminal(+)tothepositiveterminalonthe

power supply.

2.ConnectthepanelPWR(J2)secondterminal(-)tothenegativeterminalonthepowersupply.

3.Plugthepowersupplyintoa120VoltAC,60Hzdedicatedoutletnotcontrolledbyaswitch.

Figure2:DCPowerSupplyConnection

Wire Exit for DC

Power Supply

Model 372-500

DC Plug-in

Power

Supply

Use 22 AWG for

Power Supply connection

RESET

LOAD

BAT

PROG

RED

PWR

MODEL XTL

TX RF RX

1 2 3 4 5 6 7 8 9 10 11 12 ... 15 16

Comentários a estes Manuais

Sem comentários

Digital Monitoring Products XTL Series Guia de Instalação Página 7

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Digital Monitoring Products XTL Series