Digital Monitoring Products XTL Series Guia de Instalação descarregar pdf (Página 16)

XTL/XTLC Programming Guide Digital Monitoring Products

MESSAGING SETUP

Messaging Setup

4.1 Messaging Setup

This section allows you to enter the information needed to send and receive messages

directly to and from the panel via email and MyAccess™ text messaging using CDMA

cellular communication. All of the name and password options below allow up to 32

lowercase characters to be entered. The Destination addresses allow up to 48 characters

to be entered. System Name is displayed with initial caps.

The transmitted messages are:

• Zone Alarms by Zone Name

• Zone Troubles by Zone Name

• Zone Bypass by User

• Arming (Closings) by User

• Disarming (Openings) by User

• Late to Close

• Late to Open

• Early to Close

• AC Power Trouble and Restoral

• System Low Battery

• Ambush

• Abort, Cancel and Alarm Veried by User

• Check-in by User

4.2 Enable Messaging

Select YES to allow the panel to send messages to three programmed destinations.

Default is NO.

4.3 System Name

Enter a unique name for the panel. The panel name is used as the sender of the

message. The text entered is displayed with initial caps. If this eld is left blank, the

panel account number

is sent.

4.4 Destination 1

Enter the rst email address or cell phone number where messages will be sent. The

message can be sent to any device (computer, cell phone, PDA) as long as a valid email

address or cell phone number is entered. When entering email addresses, press the

7 digit key followed by the fourth Select Key to add the @ symbol and the 9 digit key

followed by the fourth Select Key to add the _ symbol. See the Entering Non-Alpha

Characters section for additional symbols.

Note: Mail servers that require Transport Layer Security (TLS) encryption are not

supported by the XTL/XTLC.

4.5 Destination 1 User Number

If Destination 1 is a 10-digit cellular number, enter a user’s user number from this account.

This option is used when sending commands such as arming or disarming back to the panel

using MyAccess™ text messaging from the same cell phone or PDA. The user number must

have the authority to perform the commands as if it occurred at the keypad. Entering 0

(zero) disables this option. Default is 0.

4.6 Destination 2

Enter the second destination email address or cell phone number.

4.7 Destination 2 User Number

If Destination 2 is a cellular number, enter the user’s User Number for

arming/disarming authorization.

4.8 Destination 3

Enter the third destination email address or cell phone number.

4.9 Destination 3 User Number

If Destination 3 is a cellular number, enter the user’s User Number for

MESSAGING SETUP

ENABLE MESSAGING

NO YES

SYSTEM NAME

DESTINATION 1

USER NUMBER:

DESTINATION 2

USER NUMBER:

DESTINATION 3

USER NUMBER:

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 48 49

Comentários a estes Manuais

Sem comentários

Digital Monitoring Products XTL Series Guia de Instalação Página 16

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Digital Monitoring Products XTL Series