Digital Monitoring Products XR20 Guia de Instalação descarregar pdf (Página 37)

XRSuper6/XR20/XR40 Programming Guide Digital Monitoring Products

zone informaTion

11.9.3

SUPRVSN TIME: XX

Supervision Time

Press any top row key to select the supervision time required for the wireless zone.

Press COMMAND to accept the default time. Default is 240 minutes.

0 3 60 240

Select the required number of minutes. The transmitter must check in at least

once during this time or a missing condition is indicated for that zone. 1100 Series

transmitters automatically checkin based on the supervision time selected for the

wireless zone, no additional programming is needed. If two zones share the same

transmitter, the last programmed supervision time is stored as the supervision time

for both zones. Zero (0) indicates an unsupervised transmitter.

Note: For UL listed installations, refer to the 1100D Receiver Installation Guide

(LT-0692) for transmitter supervision time requirements.

Note: When the panel is reset or a receiver is installed or powered down and

powered up, the supervision timer restarts for all wireless zones.

11.9.4

LED OPER NO YES

LED Operation

This only displays when programming a panic or pendant transmitter. Select YES to

turn a panic or pendant LED on during normal operation. Select NO to turn the LED

off during normal operation. The LED always operates on all transmitters when the

transmitter case is open and the tamper is faulted. Default is YES.

Note: For listed holdup installations, set LED Operation to NO.

11.9.5

NEXT ZN NO YES

Next Zone

Select YES to return to the ZONE NO: - prompt to program a new zone. Select NO

to display the Alarm Action option.

1100 Series Key Fobs

For an 1100 Series Key Fob set the House Code from 1 to 50. See House Code programming in System

Options. Only zones 31-34 or 41-44 can be programmed as 1100 Series Key Fob zones. Refer to the 1100

Series Key Fob Programming Sheet (LT-0706) supplied with the 1100D/1100DI/1100DH Wireless Receiver

and the 1100 Series Key Fob Install Guide (LT-0703) as needed.

To operate arming and disarming properly, the Key Fob should be assigned to a User Number with

appropriate area assignments, however, the User Number does not have to exist at the time the Key

Fob is programmed. The User Number can be added at the User Menu later by the User.

Note: Key Fobs have not been investigated by UL and are not intended for UL listed applications.

The following programming continues from when Key Fob YES is selected.

11.10.1

KF USER NO:

Key Fob User Number

Enter the User Number used to identify the key fob user and their arming and

disarming authority. Default is blank.

— User number 1 to 16 on XRSuper6 panels

— User number 1 to 32 on XR20 panels

— User number 1 to 64 on XR40 panels

NOT IN USE

Displays when the User Number entered does not exist in User Code programming.

The key fob can be added, but the user must eventually be added to cause the key

fob to operate.

11.10.2

SERIAL #: -

Key Fob Serial Number

Enter the eight-digit serial number found on the wireless device.

ALREADY USED Zxx

Displays when the serial number is already programmed. The programmed zone

number displays.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 51 52

Comentários a estes Manuais

Sem comentários

Digital Monitoring Products XR20 Guia de Instalação Página 37

Comentários a estes Manuais

Manuais e produtos relacionados com Sistemas de segurança - controlo de acesso Digital Monitoring Products XR20