Digital Monitoring Products XR550 Manual de Instruções descarregar pdf (Página 63)

XR150/XR350/XR550 Series Programming Guide Digital Monitoring Products

STOP

Stop

19.1 Stop

Save Programming

WHEN ANY PANEL PROGRAMMING IS CHANGED, THE STOP ROUTINE MUST BE RUN

AND ‘SAVING PROGRAM’ MUST DISPLAY ON THE KEYPAD IN ORDER TO SAVE THE

PROGRAMMING CHANGES.

At the STOP option, pressing any Select key allows you to exit the Programmer function of

the panel. When selected, the panel performs an internal reset and exits the programmer.

The STOP routine causes the following conditions to occur:

• All 1100 Series DMP Wireless transmitters are reset to NORMAL

• The panel Status List is cleared

During the reset, all keypad displays are momentarily blank for two seconds. After the

reset, the programming function terminates and the keypads return to the status list

display.

The STOP option does not disarm the system. Any new areas or zones that were added

during programming are not armed until the system is disarmed and armed again.

Missing LX-Bus™ Modules Displayed

The Programmer includes a feature following the STOP routine that displays the name of

any programmed LX-Bus module not currently connected to the panel.

Power Up

When the panel is powered up after an AC power failure, any zone transitions are not

recognized for 60 seconds. Normal zone processing resumes at the end of the 60 seconds.

Set Lockout Code

20.1 Set Lockout Code

Pressing COMMAND at the STOP option displays SET LOCKOUT CODE. This allows you to

program a code that is then required to gain access to the panel internal Programmer

through the keypad. You can change this code at any time to any combination of numbers

from three to ve digits long. You do not need to enter leading zeros when using the

lockout code. Initializing the panel does not clear a Lockout Code. Lockout Codes can be

changed through Remote Link.

Once you have changed the code, it is important to write it down somewhere and store it

in a safe place. Lost Lockout Codes require the panel to be sent back to DMP for repair. You

may cancel a Lockout Code by entering 00000 at the Set Lockout Code command.

Lockout Code restriction

Do not set a Lockout Code higher than 65535.

STOP

SET LOCKOUT CODE

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 77 78

Sem comentários

Digital Monitoring Products XR550 Manual de Instruções Página 63